Official Luthiers Forum! http://www-.luthiersforum.com/forum/
Check out this rosette http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=1584	Page 1 of 1

---

Author:	LanceK [ Tue Apr 05, 2005 5:14 am ]
Post subject:
I stumbled by this rosette this morning at Huss and Daltons site, I quickly added it to my TO DO list!

---

Author:	tl507362 [ Tue Apr 05, 2005 5:27 am ]
Post subject:
Lance, Do you think that is curly koa between the herringbone? Tracy

---

Author:	LanceK [ Tue Apr 05, 2005 5:30 am ]
Post subject:
that'd be my guess -

---

Author:	Michael Dale Payne [ Tue Apr 05, 2005 5:53 am ]
Post subject:
boy the last band of b/w/B/w/b is way closer to the sound hole than I have ever gone. I'd chip that sucker out for sure.

---

Author:	Brock Poling [ Tue Apr 05, 2005 6:04 am ]
Post subject:
You could cut the sound hole with one of those schneider razor cutter things (technical jargon ). That would probably prevent chip out.

---

Author:	jfrench [ Tue Apr 05, 2005 7:22 am ]
Post subject:
Yup... I am a true believer in scoring lines before routing them. It prevents chip out quite well.

---

Author:	bob J [ Tue Apr 05, 2005 10:50 pm ]
Post subject:
How about ebony or ? on inside edge of hole?

---

Author:	Dave-SKG [ Wed Apr 06, 2005 12:45 pm ]
Post subject:
I am almost affraid to post this but I will anyway. I think that the wood rosettes we have seen posted on this site are all realy spectacular. For me I won't buy another pre-made typical rosette ever again. BobC set me up with enough exotic wood for a couple years on my build schedule...so from here on out it natural for me. I like it! I like binding the sound hole idea too. It's just a nice extra touch that says hand made ( to me anyway).

---

Page 1 of 1	All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/